![]() ![]() " Run in background" - prevents/allows Zoiper to run while device screen is Off. Note: Ii might drain your battery really fast when used with UDP accounts. " Stay Awake" - prevents registration loss by waking up Zoiper at specific intervals. You might need to adjust these separately. Note: It cannot overwrite "Keep wifi On during sleep" in the Android Wi-Fi Advanced settings or the default Android powersaving policy. " Wi-Fi keepalive" - prevents Wi-Fi from sleeping when device's screen is Off. It is best to use TCP if it is supported by your VoIp provider. Go back to Accounts -> select your account and then scroll down to " Network settings"Īdjust Transport type according to your provider's recommendation. Go back, open Advanced and enable " Run in background". Go to Config -> Connectivity and enable " Wi-Fi keepalive" and " Stay awake". Receiving calls when running in background You might want to turn off STUN and / or Rport for your account. It is recommended to use TCP transport for SIP accounts, if this transport type is supported by your VoIP provider. ![]() ![]() Zoiper supports TCP, TLS and UDP transport. You need to make sure you are using the proper transport type. To be able to receive a call with your Zoiper for Android you need your account to be registered with the VoIP server. How to configure your account with Zoiper for Android Zoiper can be used with thousands of VoIP providers worldwide.įind a list of popular VoIp providers in your area Thanks for posting your solution SilkBC, I had bee going crazy crawling over the freeswitch logs.To be able to make and receive calls to fixed and mobile numbers you will need a VoIP account. I set up another route for the second domain with same conditions as those that had previously failed, and included a limit of 100.Įxtensions from the second domain can now make outbound calls.īefore I came across this thread, it just looked to me (haven't touched FS in years) like the outgoing calls just were just staying in the internal profile's dialplan (Checking for feature codes, etc) but the "dialplan regexp" was never checked. I finally came across this thread, and thought I'd give it a try. So I set up a new Out Bound route for the second domain using same conditions and gateway. I then added a second domain, copied the Outbound Route and changed the domain and context, but extensions in the second domain could not call out. In my case, I set up an outbound route for the "primary domain" of my FusionPBX install and it worked just fine. I am guessing you would need to see the log of the call, which I am happy to provide, but wanted to see if it is here I would post it, or should I upload it somewhere instead and provide a link to it here? I have looked through the log and located the info for my call, but I can't see it giving any actual reason for the call failure. When I attempt to call out, I get a message saying "The number you are calling is temporarily unavailable" Under "Advanced > Access Controls", I added the IP address of the VoIP.ms gateway I am using (made sure to put '/32') to the "domains" configuration. I chose "10 digit long distance" but I also tried just "North America" too. I followed the steps in the FreePBX docs to create an outbound route. I can make internal calls to another extension I created. I have created an extension and I have my softphone (Zoiper) registered to it. I created a sub-account in my VoIP.ms, and I have a gateway registered. I am just playing around with a new install of FusionPBX I did the other day, giving it a bit of a test drive.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |